|
NW KS | This is what I use for my bluetooth adapter. It cost me under 50 dollars to build. I used the 12v power pin on the display to power the adapter. The other three pin go to RS232 TX, RX and Ground. Some people advise against using the display 12v power pin to power the adapter, but I haven't had a problem using it. I have used this adapter for the last two years and never had a problem with it. The Bluetooth adapter can be found on ebay by searching for "DIN Rail Mount Serial RS232". It comes with a plastic mount that can easily be removed and the circuit board can be placed in plastic project box from radio shack. Only problem I have with this adapter is when I forget to discount the ntrip app and get out of the tractor. Sometimes it won't connect and I have to restart my phone. Not sure if that is the adapter's fault or my phones fault.
 (IMAG0284.jpg)
 (IMAG0285.jpg)
Attachments
----------------
 IMAG0284.jpg (61KB - 196 downloads)
IMAG0285.jpg (69KB - 220 downloads)
| |
|
Ntrip setup on Fmx 1000
