AgTalk Home
AgTalk Home
Search Forums | Classifieds (3) | Skins | Language
You are logged in as a guest. ( logon | register )

John Deere RTK reciver vs Trimble reciever
View previous thread :: View next thread
   Forums List -> Precision TalkMessage format
 
Canucker
Posted 11/21/2014 22:19 (#4193257 - in reply to #4192463)
Subject: RE: John Deere RTK reciver vs Trimble reciever


No luck finding a solution for the 750, but for the FMX on a CNH guidance ready vehicle you put a 76442 cable into the 12pin nav connector, hook it to a 75741 cable into either of the two ports below the power buttons. Cabling guide rev 65B page 31.

I don't see any guide instructions for using an EZ-steer of EZ-Pilot with an external receiver, but it seems the FMX can receive GPS data into port A or B. It's a matter of can it then send that data to the steering in an ez-steer or ez-pilot system or does it have to go from the Nav to the display.

If you're just doing guidance without a steering system I can't see there being any difference in branding of the receiver sending GPS data to the FMX. As long as the proper NMEA strings are coming in it shouldn't matter if it's Trimble, JD, Outback, Raven, Autofarm, and anyone else I missed. Just gets a little trickier if you want to steer as well.

Edited by Canucker 11/21/2014 22:21
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete cookies)