|
NE CO | The touchscreen on my AFS Universal Display Plus has died. I was still able to record yield and mapping data on the display. When I exceeded the display mapping data limit, the screen defaulted to the error message, although if I rebooted, I could still get a brief display of the total bushels, etc when the monitor powered up for a bit before it defaulted to the error message. Bushels, acres, etc were updating as expected. The dealer suggested downloading the data card to see if that would clear the error message. Unfortunately, after I downloaded the card data to my computer, the load for the field was cleared and until I can input a load name, the monitor will not record anything.
My question is, can a field and load name be loaded to the data card so that when it is plugged into the monitor it has a load to save data to? The screen is completely dead and I can think of no other way to start the monitor recording again. Any suggestions are welcome.
Edited by COdrylander 10/26/2014 11:41
| |
|
Field/load setup to AFS Universal Display Plus
