AgTalk Home
AgTalk Home
Search Forums | Classifieds (66) | Skins | Language
You are logged in as a guest. ( logon | register )

500T Drill controller tune function
View previous thread :: View next thread
   Forums List -> Precision TalkMessage format
 
torn
Posted 10/28/2014 21:24 (#4149697 - in reply to #4145246)
Subject: RE: 500T Drill controller tune function


roaming
tenntemp - 10/26/2014 05:45

Can someone please explain this feature for me. Having difficulty with reliable seed rate . Very confident in accurate and multiple calibrations. Controller tune sounds like something that could help but very limited information on it in the book. Thanks

As I understand it, Controller Tune is for striking a balance between responsiveness and stability. Too high, and the system "goes crazy" - i.e. the erratic behavior you're describing. Too low, and the system doesn't respond fast enough to the incoming commands. So I would try lowering the value a significant amount at first, to see if it appears to make a difference. Assuming it does, then continue decreasing if needed, or increase if you went too far the first time.
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete cookies)