|
| Bought a used 8180 White Planter over the winter. Got all my monitors mounted in the cab and over the weekend I hooked it up. When I was plugging everything in I noticed there is an extra plug on the planter that I have no where to plug into the wiring from the monitor. Traced the wire back on the planter and it goes to a sensor on one of the parallel arms. It is clearly not factory because the bracket is home made and the wires are different than everything else. What could this be? I believe it is a way for the monitor to know that the planter is in the raised position so that it will not beep at you while turning around but how do I wire it in? I have all the same stuff that the previous owner had but there is not plug or wires for it. It has a SM 4000 monitor. Any suggestions?
Thanks, | |
|