|
roaming | yes, you could output GPS from the NavII. If it is an Autopilot system, then the NavII diag connector is a 9-pin (DE9) serial connector, so you need a serial cable to connect that to your device. If the NavII is part of an AccuGuide system, the diag connector is a 12-pin Deutsch, and you can use 380002422 to connect that connector to your other display. Then you just need to configure the nav to output the desired NMEA strings, baud rate, lat/long precision, hertz rates, etc. | |
|
Case AFS / Trimble expert?
