I've been getting a f#118 critical fault on my AutoPilot. This is on a MT765 with and FM1000 and Trimble NAV. Both translator firmware and NAV firmware are up-to-date. The FM1000 also has newest software. Based upon information from another NAT post I today cut the battery power for about a minute then turned it back on. I went into the tractor turned on the key, accepted the ISOBUS, and then turned on the NAV and FM1000. No fault code came up. I then power cycled everything and rebooted and I got the fault code. So I went back outside cut the battery power for a minute and turned it back on. I then powered everything up and no code. What do you think is going on? Is it a possible translator issue? What would cutting battery power change?