12' cut per pass. I'm running 12" deep in the pic's, & they'll clear about 2x the trash as the CIH 165 I have sitting "just in case" in the weeds.  
 The "dead"  Rocks in Wy ( the 1's that had never been moved) would break a few shares, seem to handle gravel well.
 Have used it on about 2000a since I got it in aug 2011.

 Few minor problems I hope Deere will fix befor the  next 1 shows up. Rear gauge wheel is a 4 bolt hub, broke it once already. Rear tire was replaced 3x befor I got 1 from GENSCO.     Center 3 point pin from Deere is too brittle, broke 2 in the 1st 300a  befor I  gave up on them, & put a grade 8 bolt in it's place. That has ran 1600-1700a so far.
 HARROW had a similar plow that didn't go far. I think BAKER makes 1 That you can also get disk blades on