|
|
Eastern Washington State | Just had my AIMS advanced panel go dead while I was looking at it tonight. I'm ugly, but not that ugly. What would cause that?
Line voltage is good.
All fuses intact.
I measured 25 DCvolts going to the panel circuitboard. Whether that's right or not, I have no idea.
The wind tonight was cutting me to the bone, and I don't really like poking test leads around a pivot panel while shivering.
Pretty hard to start the pivot up when the panel is dead!!!!!
Any thoughts?
Thanks,
|
|
| |
|
Pasco WA. | I had an AIMS panel do that a couple of years ago. Turned out to be a bad power supply. I have no idea how to troubleshoot them though. Have you found a Zimmatic dealer with a service department? Our local dealer forgot about that part of the dealership. |
|
| |
|
Eastern Washington State | Jay,
I'm not that far from you so your local dealer is probably my local dealer. I'm a 3 year veteran to this pivot stuff. I've troubleshot tower boxes and centerdrives and collector rings, but when it comes to circuitboards and LCD displays I'm LOST.
Tim |
|
| |
|
Pasco WA. | If your using my local dealer good luck with the service call. I have heard that their is good service out of Othello and Moses Lake, you might try going that way. |
|
| |
|
Eastern Washington | Try Jeremy at ECS Northwest in Pasco, Very sharp but very busy, Probabley the power supply, he jumpered one of mine and made it go. Only guy I will let work on my telemitry and pump panels.
Edited by DBH 4/10/2010 23:49
|
|
| |
|
| I feel your pain. I can do most stuff after it gets out of the control panel, but that often confuses the dealer. This is why I rely on T&L pivots. They are so simple even I can fix anything on them.
Edited by R.S. DeMernly 4/11/2010 11:35
|
|
| |
Zimmatic AIMS Advanced panel problem
