|
SW KS, near Dodge City | OK, I know I asked before, but I've gotten schematics to make a wiring harness to put the EZ boom the the Rogator... Problem is that I'm not sure if it's exactly what I was looking for.
Looking at the schematics, it appears that the Raven controller is completely bypassed. I didn't think you could do that w/ a 1254 Rogator w/ the pump servo control. Schematic I've got shows 2 16 pin connectors, 1 goes in the EZ boom, 1 goes in the Raven harness. It also shows the 12 pin duetsch connector to tie into the Rogator's boom valves. Then it has a weatherpack (1 tower) to tie into switched power. From my understanding, w/ the Rogator I was going to have to use the 661 to control the rate. That would involve a 16 pin connector going from the ez-boom to the 661 and also tee-ing into the raven harness, in addition to running to the external boom switches, wouldn't it?
Does anybody know, can the EZ-Boom control the pump servo on the 1254 Rogator?
Edited by pknoeber 5/13/2008 19:59
| |
|
EZ-Boom on 1254 Rogator, cabling question...
