|
Iowa | I see some Greenstar questions below. Here are mine:
Just bought a 9610 w factory Greenstar w/o GPS. Former owner said works good, so I assume it does work from cabpost speed reading. Please walk me through using it.
1) Head width-- Cornhead is simple, but what about beanhead going diagonally in 15" row beans. What width should I put in for a 925 since I know I don't cut a completely "full" 25'?
2) Do I use the Greenstar on a load or two, then weigh the loads and somehow calibrate it to match the scale weight?
3) Assuming I calibrate the weight somehow (see question 2), must I do it again for each different crop?
4) I know NOTHING about precision ag, not even enough to ask the right questions. Any help for a beginner using Greenstar would be GREATLY appreciated.
5) What does it take to have mapping in addition to yield monitoring? I'm sure I would need GPS, and additional hardware. What would I need and how much $$ would it take?
Thanks in advance for the help. Any insight--nothing is too remedial for me,Tommy | |
|
More Greenstar questions
