|
se ne | I need to replace the injector pump on a 4020. I searched archives but didn't find much detailed info. I was told to line up TDC mark on flywheel to mark on side of inspection hole, but if they didn't line up to turn it one more turn. I turned it (several rounds) with a screwdriver and came right on everytime. Is this right? It is the pump where all lines come in on the top to the round part and it sticks down into the block and is clamped down by a couple bolts. When I get it to TDC can I just pull out pump and put in new one or is there something I need to watch for. | |
|
JD 4020 replacing injector pump
