Near Intersection of I-35 & I-90 Southern Mn. | Apparently when the FMX is set in English, the Programmers expected that it would be talking to a Metric controller setup in metric. Then the conversion of 9.3 would be correct.
However when the FMX is operating in English and the controller is operating in English then the conversion should not be taking place.
otc59 apparently saw the same problem. Sounds as if the newer firmware addresses this problem. If not, possibly the unconverson number of .107 can be entered if there is a menu item that allows this.
Otherwise the software creating the Rx might be tricked to output values that when converted workout properly.
Edited by tedbear 11/20/2009 07:15
|
FMX to Raven Serial
