|
ECMN | It has been 20 years since I touched a set of king pins. A picture of what you are seeing on the axle would be helpful. Is there a hole to place a punch in from the other side and drive it out? If not maybe a vise grip? May have to weld a nut on it, maybe a heavy washer first, but grind the washer edge down on opposite sides so you can get a pry bar under the nut you weld on top. When you get it out may be a good idea to drill a 3/16” hole on through so next time they can be drove out even though it is a good chance this is the last time they will be replaced. Fill the hole with RTV so the road yeck stays out. | |
|