|
SESD | They seemed very good, although I only have 2 years on mine. The new bins and bushings are a snug fit. I did have a few rows where the pin spun in the arm instead of the bushings because they got a little rust and stuck. I went threw and sprayed with lube and made sure they were all loose, otherwise you will have other problems. One think to keep in mind since you just turned your current pins. There will still be the same amount of play in the opener. The important thing is that the opener will be running at the correct angle if the pin was rotated and doesn't doesn't have much wear. The openers only pull one way, so if the pins are good and bushings OK, you should be fine for some more acres. | |
|
JD 1890 opener arm pivot pins and gauge wheel rubber ?
