Here's some photos, when I did mine, But I was doing a radiator at the same time, too.

{I do think there are two different pumps, as far as volume, goes. They show 50 cm and 65 cm} I do know it makes a different on fitting size/ports, when you go to order one. Mine was power shift, and I know, it made a difference, on those ports; but I think the parts guys, said if it had been a synchromesh, then he wasn't quite as worried about the ports (They must be more similar, on synchromesh, I assume)

I purchased new, not rebuilt, during a sale period.

(straps to hold front tires straight.jpg)

(eyebolt and fitting threaded into housing port.jpg)

(lifting tool (1).jpg)

(Homemade stands with scaffolding leveling screws.jpg)

(homemade stands.jpg)

(lifting hyd. pump.jpg)

(pivot support.jpg)

straps to hold front tires straight.jpg (163KB - 220 downloads)

eyebolt and fitting threaded into housing port.jpg (139KB - 219 downloads)

lifting tool (1).jpg (97KB - 248 downloads)

Homemade stands with scaffolding leveling screws.jpg (129KB - 231 downloads)

homemade stands.jpg (112KB - 244 downloads)

lifting hyd. pump.jpg (123KB - 236 downloads)

pivot support.jpg (94KB - 255 downloads)