Between Omaha and Des Moines, 7 miles South of I80 | I'm thinking of buying my own nitogen test/charging equipment for JD combine Hyd. accumulators with Schaeder valve style fitting.
My book says roughly 800 +/- 100 psi; and also explain the drop test and measurements. (1/2 gallon size)
I haven't seen the actual JD type tooling, but this one I found on this link, sure looks like it will work fine. (And if I find a problem with mine, You guys have posted before, to just use that same tooling, go to combine "recycle yard" and test a used one, until you find one that holds psi good. = much, much cheaper than new, was mentioned, too)
Any comments, on this tooling; or any other similiar tooling, would be welcome. Thanks
http://catalog.hydracheck.com/viewitems/accumulator-products/ulator-nitrogen-charging-valve-and-hose-assemblies
Edited by 4WD 5/31/2013 16:26
|