|
Minnesota | after you finish going through the field setup screens, and return the the mapping page on the 750, on the right side of the screen you should find a "boundary start" button. It will be the second row of buttons out, under "Map A Point" "Map B Point". You will also have the option to "pause boundary", but as soon as you get close to where you started the boundary, you should be able to hit the "close boundary (or Stop Boundary)" button to finish it (will be in the same spot as Boundary Start if I remember correctly.)
If the boundary options are not coming up, you may need to go into Settings -> Guidance -> Boundary Setup, and enable the boundary settings on the display. Just going off the dealer simulator for the above. If none of that works, I would check which version software is in the display, might be some of the earlier firmware versions left boundaries out. | |
|