|
| I ran into a similar problem this Spring. First go in and check your roll and yaw in your 3000 receiver through the 2600 display. You might notice them moving around a lot, at least this is what I seen. You will want to unplug your receiver from the tractor for awhile before plugging it back in.
Once you plug it back in make sure you have a card with the lastest software on it in the 2600. Go into the message center, then to the page where it has a big piece of paper with an arrow pointing to a smaller piece of paper. Highlight your GPS receiver and hit "Reprogram Device". Take the receiver software back to an old version, and then go back in and have it re-update to the newest version.
Once I did all this the tractor/receiver started working great again and he used it the rest of the spring. | |
|