|
| Hi. I just finished installing a pair of Kile rotor flights on my 1680 today. Figured I'd post a few pics for those that have'nt seen them in a machine yet. I had Ron Kile make the wear blades a little longer and out of mild steel instead of the usual hard stuff so I could sharpen them. He cut them just the right amount longer too, as they fit perfectly. Please excuse my slobber job of laying on the studite rod. The plate was a little thick for my torch and I had to use the cutting tip to get things hot enough without drawing too much acetylene too fast. Anyway, it got put on, and it will work fine, just looks like heck.
Should be 5 pics in this post, then 5 more in a second post. Been having trouble posting pics here for quite a while so I have to do it in two settings.
(IM001520.JPG)
(IM001521.JPG)
(IM001524.JPG)
(IM001525.JPG)
(IM001526.JPG)
Attachments ----------------
IM001520.JPG (90KB - 607 downloads)
IM001521.JPG (114KB - 577 downloads)
IM001524.JPG (96KB - 636 downloads)
IM001525.JPG (119KB - 544 downloads)
IM001526.JPG (82KB - 585 downloads)
| |
|