|
Madision County, IL | Went out early this morning and worked with it again.
Watched minimum turn sensitivity closely. Wheel started turning at 28%. Ran the numbers from 14% to 28%. Is it really necessary to input ECU orientation (the cables are facing forward) and recalibrate tilt every time we want to adjust the minimum turn sensitivity? I saw very little too no steering improvement. The tractor is weaving back and forth accross the line.
GPS is outputing to Edge at 38400 8 N 1 with a position update rate of 10HZ. It is mounted at the front edge of the tractor cab.
ECU is mounted in the tractor cab behind the rear axle. MDU seems to be working fine.
Is it necessary to have GPS connection to perform tilt calibration?
Thanks,
Jay | |
|
Edge, OnTrac2 and AgGPS 162 on Agco 9675 MFD
