|
| This is the shaft and bearings that come vertically up out of the gearbox at the back end of pto. It connects to the u joint that then connects to the swing away portion of the auger. There is a little bit of wobble in the shaft. We would like to take it apart to look at the bearings. We've put some pressure on the shaft but haven't had any luck. Any ideas or experience with this. Just more pressure? TIA. Below is a picture
 (image.jpg)
Attachments
----------------
 image.jpg (122KB - 91 downloads)
| |
|
Brandt auger shaft - how to dissemble
