|
East Central Minnesota | Tractor acted like it was under a heavy load in 1st powershift range and would totally stall out in reverse when the clutch was released. But did move fine in 2nd and 3rd range. I took the control unit off and cleaned up and made sure all the spools were moving freely. I didn't really find anything obvious and put everything back together.
Now the tractor will start moving in 1st and reverse and then will just quit moving after going 20-30 feet - until I increase the rpms, then it will jump forward or reverse and seem to run fine until I decrease rpms, then it stalls out again and won't move. All other hydraulics seem to work fine - brakes/steering.
I took the control unit off again since the symptoms changed after going through it the first time and it still acts the same. Any other ideas before I give up and bring it to a repair shop?
Thanks | |
|