I was at a new Flexi-Coil drill today to setup Rx maps and every time we cycled the power on the Pro600 the Work Condition I created would be wiped out and I would have to setup the layers again.  The unit appears to be reading the card properly as the Rx files and field names load up. The unit appears to be working fine once you have all of this setup but it's very annoying to have the operator do this every time they start the unit.  Is this common with these units or a problem with this particular one.  The system has been updated to the current version of 26.  I did notice that when we turned the key off that as the display was shutting down a hand on the card icon with a red x would appear.

Any comments would be appreciated.