|
| I've had the worst luck with insight monitors except that they are pretty cheap. The insight in the combine has a screen that is going (been fixed once) and I've done the credit card clean out between the screen and bezel, however the side "buttons" are intermittent. It wouldn't so bad but it stops reading yield randomly. The floor in my 2188 grain tank "booms" (vibrates) more when empty the past couple of years and I wonder if I'm adding more vibration noise? Unfortunately I don't think I can do a calibration since the tools buttons is one that doesn't currently work.
Is this a typical insight failure mode or do you guys think my yield sensor is going? thanks | |
|