|
| I'm having a problem with a 2007 steiger accuguide ready tractor. I have pro 600 with v26, nav II on 3.65, and 262 receiver. The display will see the 262 on CAN B, not CAN A. The display will get DGPS with the NAV turned off. If I turn the NAV on. I don't get any GPS, status of wait 0. I've tested continuity on the RS232 TX, RX, GND, and PPS wireles between nav and 262 and that tests out. On the display under CAN - I can see the nav on the can, and if I switch the GPS location to CAN B I can see the 262 on the CAN, but still no gps with the NAV on. I'm thinking the 262 needs to be on CAN A and wondering if that is causing my problems. This steiger has the original accuguide harness, as I believe the made a change in the harness after a few hundred were made....... Any help on why I'm not getting GPS on the display with the nav on would be appreciated. Thanks | |
|
CAN issues on early steiger accuguide
